Placements, presets and print areas in PwrMockup
Last reviewed Lees dit in het Nederlands
Use presets such as left chest, large front or upper back, or place artwork freely in cm, mm or inches. PwrMockup warns when a print leaves the recommended print area.
Presets
Presets place your artwork at a common position and width. You can adjust them afterwards.
| Product | Presets (default width) |
|---|---|
| T-shirts | Left chest 90 mm, Right chest 90 mm, Centre chest 100 mm, Large front 280 mm, Upper back 250 mm, Large back 300 mm, Left and Right sleeve 70 mm |
| Long sleeves and crew sweaters | As T-shirts, plus Forearm (120 mm) and Above cuff (50 mm) on each sleeve |
| Hoodies | Left chest 90 mm, Centre chest 240 mm, Upper back 280 mm, Large back 320 mm, plus sleeve, forearm and above-cuff presets |
| Kraft carton | Top, Front, Back, Left side, Right side |
Quick sets: Chest + back and Front + back.
Sizes and units
Sizes show in cm by default; you can switch to mm or in. Sizes are real print sizes on the chosen garment size.
A mockup can hold up to 20 prints.
Recommended print areas
Each view has a recommended print area, based on the garment's measurements: for example on the front and back up to 356 mm wide, starting 60 mm below the neck, and 90 mm wide on a sleeve.
If a print goes outside it, PwrMockup warns: "Outside the recommended print area. That is fine for a visual; check with your printer before production." It also warns when a print goes beyond the surface, over a pocket or over a seam. These are warnings, not blocks.
Was this article helpful?
Still stuck? Ask Rose or contact support.
Rose, our support assistant, answers right away and can look into your account. Prefer a person? Ask Rose to pass it on: a person replies within 1 working day, in English or Dutch.